Amada HFA-400 - Page 109

IV-31
5 Press the numeric
keys “1” and “0” and
the ENT key to set
“10.0” in the L field
and move the cursor
to the P field.
6 Press the numeric key
“3” and the ENT key
to set “3” in the P field.
7 Once the quantity of
pieces to be cut is set
in the P field, the
cursor moves to the
ST. field. The station
number is increased
by 1 to “2”.
8 Press the ENT key to
move the cursor to the
L field.
9 Press the numeric
keys “2” and “0” and
the ENT key to set
“20.0” in the L field
and move the cursor
to the P field.
10 Press the numeric key
“5” and the ENT key
to set “5” in the P field.