III-15
The cutting fluid flows to the positions A, B, and D when the lever of the
three-way cock installed at the right side of the chip outlet is turned to
the right side, flows to all of the positions A to D when the lever is turned
to the middle position, and flows only to the position C when the lever is
turned to the left side.
Normally, keep the lever at the middle position so that the cutting fluid
can flow to all of the positions A to D.
Adjusting cutting fluid flow rate
The cutting fluid is discharged from the nozzles A and D for cooling and
lubricating the saw blade. Discharge the cutting fluid at the highest
rate above which the cutting fluid splashes.
The cutting fluid is discharged from the nozzle B for removing the chips
from the saw blade. Discharge the cutting fluid at the highest rate
above which the cutting fluid splashes.
While the machine is cutting the work, insert the nozzle C in the wire
brush cover and use it for removing the chips from the wire brush.
When dry cutting the work, turn the lever of the three-way cock to the left
side, and discharge the cutting fluid only from the nozzle C. When
cleaning the machine, remove the nozzle C from the wire brush cover,
and wash away the chips with the nozzle C.
To Next Page
Loading...
