Communications Options
6-26 M370430-01 Rev B
to each computer that you will be using to access the
XG/XTR unit (s) over the Ethernet. If copying the files is not
possible, repeat step 3 for each computer that you wish to use.
The configuration is complete. You are now ready to use your system.
Controlling Your System
For every connected XG/XTR unit, create a separate terminal session.
This should have been done according to the instructions in
“Establishing Communication with the Power Supply” on page 6-22.
Also, open a separate HyperTerminal session for each XG/XTR unit
that you wish to control. An example of two units in a system is shown
in Figure 6-31.
Figure 6-31 HyperTerminal Session
To Next Page
Loading...
