SCPI Command Reference
A-2 M370430-01 Rev B
SCPI Conformance Information
Codes and Standards
This power supply conforms to the following international
standards:
IEEE Std. 488.2-1992, “IEEE Standard Codes, Formats, Protocols,
and Common Commands For Use With IEEE Std. 488.1-1987”
IEEE Std. 488.1-1987 “IEEE Standard Digital Interface for
Programmable Instrumentation”
TIA/EIA-232F
Standard Commands for Programmable Instruments (SCPI)
Version 1999.0
IEEE 488.2 Requirements
GPIB control implements all IEEE 488.2 requirements.
SCPI Requirements
The power supply conforms to the following SCPI requirements:
SCPI mandated commands
Questionable Status Register (QSR), Condition, Event, Enable
Operation Status Register (OSR), Condition, Event, Enable
Status Byte Register (SBR)
Standard Event Status Register (SESR)
IEEE 488.2/SCPI Syntax and Style
Parameters: Units of Measure and Multipliers
Refer to IEEE 488.2, section 7.7.3 for the definition of units of
measure. The default units of measure include:
V (Volt - voltage)
A (Ampere - current)
W (Watt - power)
S (seconds - time)
These units are only supported as defaults. To place the unit in the
command will cause an error to be pushed into the error queue.
To Next Page
Loading...
