Analog Programming (APG) and Isolated Analog Programming (ISOL)
4-32 M370430-01 Rev B
Voltage and Current Readback (Isolated)
The pin numbers are described in Table 4-4 on page 4-21.
ISOL Connector
Figure 4-15 Isolated Voltage Monitoring
ISOL Connector
Figure 4-16 Isolated Current Monitoring
Query Remote Control Source State
Quick Tip Remote
operation uses these
SCPI commands. See
page 5-1.
The SCPI command for these instructions are:
[:]SYSTem[<channel>]:REMote:SOURce[:VOLTage]?
[:]SYSTem[<channel>]:REMote:SOURce:CURRent?
To Next Page
Loading...
