Local Operation
M370430-01 Rev B 3-7
Normal Display Mode and Inactivity Timeout
Normal display mode appears on the output voltage and current
displays when the configuration changes from the front panel have
been completed or when the inactivity timeout occurs (default is 3
seconds). Normal display mode shows the output voltage and
current values.
If a timeout occurs before the changes made to the value have been
set, the changes will not be saved and you will have to re-enter the
changes. The inactivity timeout is variable from 1 to 20 seconds
and can only be changed using the SCPI command.
The SCPI command (s) for these instructions are:
[:]SYSTem[<channel>]:FPANel[:TIMeout]
Important: Each user memory setting location stores the timeout so that
beginning users and expert users are not required to use the same timeout
To Next Page
Loading...
