Ametek Sorensen XG - Basic Setup Procedure

Installation
2-2 M370430-01 Rev B
Basic Setup Procedure
Table 2-1 provides a summary of the basic setup procedure with references to the relevant
sections in this chapter. Refer to this table if you are unfamiliar with the installation
requirements for the power supply. Complete each step in the sequence given.
Table 2-1 Basic Setup Procedure
Step
Description
Action
Reference
1
Inspect
Inspect the power supply.
“Step 1: Inspecting and Cleaning”
on page 2-3.
2
Install
Install the power supply
(benchtop or rack mount).
Ensure adequate ventilation.
“Step 2: Location and Mounting” on
page 2-4.
3
Connect Input
Power
Connect AC input power.
“Step 3: Connecting AC Input
Power” on page 2-5.
4
Select Wires
Select wires that are correctly
rated for the maximum DC
output current.
“Step 4: Selecting Load Wires” on
page 2-8.
5
Te s t
Perform functional tests for
voltage mode operation, current
mode operation, and front panel
controls.
“Step 5: Performing Functional
Tests” on page 2-10.
6
Connect Loads
Connect the load wires to the
DC output.
“Step 6: Connecting Loads” on
page 2-12.
7
Connect Remote
Sensing (if
required)
Connect remote sensing
connectors on power supply to
load.
“Step 7: Connecting Remote
Sensing” on page 2-15.