Ametek Sorensen XG - SCPI Command Summary

A-14
M370430-01 Rev B
SCPI Command Reference
SCPI Command Summary
The SCPI commands supported by this programmable power supply are described in the tables in the
remainder of this section. These tables use the following column headings:
Function The commonly used name for the function.
SCPI Command The full command in long form.
Description Explains what the command does or what is affected by it.
Query? Indicates whether the unit supports a query version of the listed command. N/A indicates Not
applicable. (The command has no query form and will respond with an error if queried.)
Table A-1 IEEE 488.2 Commands
Function
SCPI Command
Description
Parameter and
Range
Query
Select Address
*ADR
Select the power supply unit
to communicate with.
?|<Address (1–30)>
Yes
Clear Status
*CLS [:]STATus[<channel>]:CLEar
Clears all the status data
structures.
N/A
Query the Error
Queue
*ERR
Query the Error Queue for the
oldest error event.
Standard Event
Status Enable
Query
*ESE?
[:]STATus[<channel>]:STANdard:ENABle
Query the Standard Event
Status Enable register
settings.
Yes
Standard Event
Status Enable
*ESE
[:]STATus[<channel>]:STANdard:ENABle
<ESE-word>
Set the Standard Event Status
Enable Register bits.
<Enable Flags(0–
255)>
N/A
Standard Event
Status Register
Query
*ESR?
[:]STATus[<channel>]:STANDard[:EVENt]?
Query the Standard Event
Status Register (SERS).
Yes