Local Operation
3-4 M370430-01 Rev B
Table 3-1 Select and Set from the Front Panel cont’d)
9 Positions on the Mode
Control Knob
Turning the rotary Adjust/Enter
control lets you...
Pressing the rotary Adjust/
Enter control lets you...
CAP (Current Analog
Programming)
Select the programming source and
select the range.
Set the value selected and cycle
to the next setting.
VAP (Voltage Analog
Programming)
Select the programming source and
select the range.
Set the value selected and cycle
to the next setting.
PGM (Programming Options)
Select the remote interface to be used
for control, local lockout or current
sharing.
Select interface/Option and
cycle to the next setting.
To Next Page
Loading...
