Ammann ARR 1575 - General Machine Overview

18 ARR1575
2 Safety measures and instructions
2.3 Fire prevention
• The oil change point must be where it cannot interfere in explosion or re hazard areas.
• It must be identied by “No smoking” and “No open ame” plates and signs.
• The handling area must be dimensioned so that it can capture avolume of the ammable liquid equal to the capacity of the big-
gest transport container.
• It must be equipped with portable re extinguishers.
• For handling the oil and diesel fuel, use metal barrels, jerry cans, sheet-metal cans and similar vessels.
• The transport containers must be properly closed during storage.
• Vessels must be with only one outlet, stored always with the outlet up and secured against the outow and drains.
• Vessels must be marked with non-removable writings showing the contents and ammability classes.
Special tools, jigs – see relevant chapters of the manual
2.4 Claim conditions and disclaimer of liability
1. Warranty rules
• Regular inspections and correct operation of the equipment
• Products have been registered at the service portal
• The equipment is operated by atrained operator
• Following parts are excluded from warranty: part subject to wear and tear, including, without limitation, rubber washers/wheels,
belts, scrapers, wipers, lters, grease, uids, conveyor parts, chains, foundation boards, compacting rods, auger elements, bearings,
fuel and consumables.
• Batteries are provided with awarranty for 12 months / 1,000 hours. After this period, batteries are included in parts subject to wear
and tear and are excluded from the warranty.
• Hydraulic hoses can be purchased from local dealers and charged as an expense to Ammann.
2. Procedure for raising aclaim
• In case of raising awarranty claim, the owner/user shall immediately submit the manufacturer acompleted warranty claim and
images of the fault. The owner/user shall also send aproof of regular maintenance before sending the warranty claim or together
with it at the latest.
• Ammann recommends that you send aproof of regular maintenance regularly.
• The document can be sent in various ways (e.g. via the service portal, service application). The document shall contain amachine
serial number and aserial number of the original maintenance kit of Ammann. This information can be provided either typed, or
scanned according to the selected manner of handover.
3. Breach
• If adealer breaches obligations stated in points 1) and 2), any warranty claims will be rejected.