Ammann ARR 1575 - Start of the Conductor and Infrared Radiation Test

287ARR1575
WORKSHOP MANUAL
18.1.2 Start of the conductor and infrared radiation test
Normal test
Open the cab cover.
Open the cover without covering the sensor.
Turn the ignition on.
Keep adistance of three metres from the roller.
Always keep an eye on the safety bar indicator lamp.
If the safety bar indicator lamp is ashing, increase the distance from the roller.
Hold down the switch button on the infrared sensor.
The preheating indicator lamp must be on.
If the preheating indicator lamp is o, reduce the distance from the roller.
When the preheating indicator lamp turns on, the roller starts after 6 seconds.
Quick start
Open the cab cover.
Open the cover without covering the sensor.
Turn the ignition on.
Keep adistance of three metres from the roller.
Always keep an eye on the safety bar indicator lamp.
If the safety bar indicator lamp is ashing, increase the distance from the roller.
Hold down the switch button on the infrared sensor.
The preheating indicator lamp must be on.
If the preheating indicator lamp is o, reduce the distance from the roller.
When the preheating indicator lamp turns on, immediately let go of the switch. Start the engine.