Ammann ARR 1575 - Electrical Installation; Preparation for Welding Work

280 ARR1575
17 General procedures
17.2 Electrical installation
17.2.2 Preparation for welding work
Welding work on aroller with an installed battery may
damage the machine control device!
Completely remove the battery before welding work on
the roller.
Place grounding cables of the welding equipment as near to the
point of welding as possible. The grounding point must be free
of paint.
Danger of injury!
Incorrectly welded castings may result in material cracks.
Welding of castings is prohibited!