Ammann ARR 1575 - Display Unit; Indicator Lamps

94 ARR1575
-
+
!
hours
555012
1 2
3
4
5
6
7
6 Cab and platform
6.1.1 Display unit
6.1.1.1 Indicator lamps
Operating hours counter (1)
RAM02
-
+
Charging indicator lamp (2)
The indication lamp goes on after the key in the ignition box
is switched into the position "I" and goes out after the engine
starts. If the indicator lamp turns on during operation or does
not turn o after starting, immediately perform the following
check.
• Turn o the engine.
• Check the V-belt of the engine for damage and loosening.
If the battery charging indicator lamp is still on after this check,
contact an authorized service centre of Ammann.
RAM01
!
Error indicator lamp (3)
The error indicator lamp turns on when the control unit detects
an error.
The inclination sensor is activated. The machine is positioned at
an angle exceeding 45°. Place the machine upright.
The wiring is faulty. Check for ashort circuit or cable break.
If the error indicator lamp is still on after this check, contact an
authorized service centre of Ammann.