325ARR1575
WORKSHOP MANUAL
Risk of burns from splashing oil! Eye damage, burns.
Wear safety goggles.
Rotate the engine with the starter
Rotate the engine with the starter (1–2 min.).
After several turns, the accumulated oil in the combustion area
should be pushed through the glow plug holes.
Repeat the process after approx. 5 min. Make sure there is no oil
in the combustion area!
Reinstall the glow plugs, tightening torque 18 Nm.
Reconnect the glow plugs to the contact connection and cables
(tightening torque 1.5 Nm).
Mount the valve cap.
Mount the electrical sheet.
Rotate the engine with the ignition key
Rotate the ignition key clockwise to the III position.
The engine must rotate.
If it does not, never attempt to start the engine!
There may still be oil in the combustion area. Repeat the proce-
dure as described above. Otherwise, immediately contact your
authorized dealer!
If the engine rotates:
Check the levels of all uids.
Rell the liquid if needed.
Reinstall the F21 fuse.
To Next Page
Loading...
