7-12
P129390-106 Operator Manual Cycle and Control Value Programming
7.4.4 Set Date At Change Time and Date screen, press Set Date and screen shown
below appears. Enter the day value using the keypad. The day value
must be between 1 and 31.
1. If an incorrect number is entered, press the backspace key to
clear the entry, then use the keypad to enter the correct value.
2. Once the correct day value has been entered, press OK to
accept.
NOTE: The day of the week is automatically understood and
registered by the control.
3. Press EXIT to return to Change Time and Date screen.
To Next Page
Loading...
