Web RCS
1. Go to the Setup menu on the Web RCS interface.
2. Click on the INPUTS tab to access the inputs setup page.
3. In the left side toolbar, select an input to access the selected input setup page.
4. Select the Signal tab to access the plug settings page.
5. Under HDCP, check the HDCP status of the input plug.
TIP: Use the Quick Setup button (located at the bottom of the Web RCS interface) to manage HDCP on all
input plugs.
Related topics:
• HDCP support
• Plug status
The SD stability specifies the stability of an SDTV signal, sometimes required to configure the hardware
accordingly.
On the HD15 input (SDTV signals only), you can specify the stability mode to use for the input signal.
Available input source stability modes include:
To Next Page
Loading...
Need help?
General
