To reset to configuration default values:
NOTE:
• Network, Web RCS and Link parameters will remain unchanged.
• Library frames and logos will not be erased.
Front Panel
1. Enter the CONTROL menu on the Front Panel interface.
2. Scroll down and select Reset to default values to start the default values reset:
• Select YES to confirm the reset (/!\ this action is irreversible).
• Select NO to cancel the action.
NOTE: The unit will reboot itself once the reset is complete.
Web RCS
1. Go to the Setup menu on the Web RCS interface.
2. Click on the CONTROL tab to access the device settings and control functions.
3. In the left side toolbar, select Factory Reset to access the resets page.
4. Under Configuration Default Value, click on the Start button:
• Click again to confirm the reset (/!\ this action is irreversible).
• Click elsewhere to cancel the action.
NOTE: The unit will reboot itself once the reset is complete.
To reset to factory settings (as-is out of the box):
NOTE:
• Network, Web RCS and Link parameters will remain unchanged.
• Library frames and logos will not be erased.