Seconds per BurstSeconds per Burst
(Burst Length)(Burst Length)
Pretest OptionsPretest Options
End to End TestEnd to End Test
(controller side)(controller side)
The check boxes are enabled except when selecting End to End network testEnd to End network test on Control
screen.
If duration RepeatsRepeats is set to 00 (zero), the test will run a single time. If it is set to 1, the test
will run two times (repeated once).
Touch a button to set seconds per burst.
When setting burst length by seconds, the burst length is searched
automatically. Select the search resolution from 0.1 %0.1 %, 1.0 %1.0 %, or 10.0 %10.0 %. Select
the search method from ModeMode.
66..99..22..77 AdvancedAdvanced
Touching the AdvancedAdvanced button in the navigation area will display the screen
shown below.
This screen allows you to specify various advanced settings for the RFC 2544
test(s).
Pretest Options
End to End Test (controller side)
Throughput Calculation Layer Selection
Miscellaneous
Throughput Type
Latency Timestamp
Transmit learning framesTransmit learning frames
When this option is enabled, the RFC 2544 test will send out a number of
'learning frames' before the first test-step starts on each port. This happens to
train network equipment, so that initial latency results will not be invalid.
In One-Way test, transmit frames fromIn One-Way test, transmit frames from
This parameter defines the direction of the frames when transmitted during an
End to End test with the One-Way setting enabled. Available directions are:
LocalLocal: The 'local' Network Master sends Ethernet frames to the 'remote'
Network Master.
The 'remote' Network Master measures the received frames.
RemoteRemote: The 'remote' Network Master sends Ethernet frames to the 'local'
To Next Page
Loading...
