ThroughputThroughput
Calculation LayerCalculation Layer
SelectionSelection
MiscellaneousMiscellaneous
Network Master.
The 'local' Network Master measures the received frames.
Use local source addresses for destination on remote sideUse local source addresses for destination on remote side
When the check box is selected, the Network Master does not use the IP or
MAC addresses for differentiating frames during the RFC 2544 test. An
exception is End to End test control, but routing equipment in the network may
need the addresses to be set up correctly. To limit the amount of needed setups
on the Remote side, this setting can be enabled to transfer the source address
setup from the Local using it as destination on the Remote. However, the
source addresses must still be correctly setup on the remote in order to make
the End to End test work.
Store test results on remote sideStore test results on remote side
When the check box is selected, test results will be stored on the 'remote'
Network Master.
Select the layer on which the throughput calculation is done. As described in
the Throughput calculation section there are 6 different layers:
Utilization layer throughputUtilization layer throughput
Physical layer throughputPhysical layer throughput
Physical layer throughput (without preamble)Physical layer throughput (without preamble)
Link layer throughputLink layer throughput
Network layer throughputNetwork layer throughput
Data layer throughputData layer throughput
Data layer throughputData layer throughput appears when UDPUDP or TCPTCP is set to the layer 4 of the
Ethernet frame on 'Ports Setup' screen.
Include addresses in frame filter on receiverInclude addresses in frame filter on receiver
When the check box is selected, the Ethernet frames which their destination
addresses match the following items will appear on the Streams screen.
Src MAC
Src IP
VLAN ID
Src Port
This setting has an effect on only the following measurement results on the
Statistics screen.
Multi Stream Transmit
Multi Stream Throughput
Multi Stream Frame Loss
Multi Stream Latency
Multi Stream Jitter
This setting does not have an effect on Frame Capture.
Accumulate repeated stepsAccumulate repeated steps
When the check box is selected, the RFC 2544 test (Throughput, Frame loss,
Latency, and Burst) is performed by steps by means of changing a parameter
value. When selecting the check box, the results of each steps are accumulated
by each test when the tests are repeated.
To Next Page
Loading...
