Anritsu MT1810A - Page 175

7.4 Automatic Measurement Commands
7-57
7
Remote Commands
measurement.
Example To query whether the slot 1, Data 1 is targeted for the Mask Test
measurement:
> :SENSe:MEASure:EDIagram:MTESt:SLOT? SLOT1,1
< 1
Compatibility Incompatible with existing models.
:SENSe:MEASure:EDIagram:DIAGram:TRANsition <type>
Parameter <type>=<CHARACTER PROGRAM DATA>
OFF OFF
TRANsition Transition
NONTran Non Transition
Function Sets Transition/Non Transition error detection.
Example To set to Transition error detection:
> :SENSe:MEASure:EDIagram:DIAGram:TRANsition TRANsition
Compatibility Incompatible with existing models.
:SENSe:MEASure:EDIagram:DIAGram:TRANsition?
Response <type>=<CHARACTER RESPONSE DATA>
OFF
Function Queries the Transition/Non Transition error detection setting state.
Example > :SENSe:MEASure:EDIagram:DIAGram:TRANsition?
< OFF
Compatibility Incompatible with existing models.
:SENSe:MEASure:EDIagram:DIAGram:TYPE <type>
Parameter <type>=<CHARACTER PROGRAM DATA>
POINt8 8 Point
POINt16 16 Point
POINt32 32 Point
POINt64 64 Point
POINt128 128 Point
Function Sets the number of measurement points during Eye Diagram measurement.
Example To set the number of measurement points during Eye Diagram
measurement to 8 points:
> :SENSe:MEASure:EDIagram:DIAGram:TYPE POINt8
Compatibility Incompatible with existing models.