Anritsu MT1810A - Calibration; Transportation

8.3 Transportation
8-3
8
Maintenance
8.3 Transportation
Use the original packing materials, if possible, when packing the
MP1862A for transport. If you do not have the original packing materials,
pack the MP1862A according to the following procedure. When handling
the MP1862A, always wear clean gloves, and handle it gently so as not to
damage it.
<Procedure>
1. Use a dry cloth to wipe off any stain or dust on the exterior of the
MP1862A.
2. Check for loose or missing screws.
3. Provide protection for structural protrusions and parts that can
easily be deformed, and wrap the MP1862A with a sheet of
polyethylene. Finally, cover with moisture-proof paper.
4. Place the wrapped MP1862A into a cardboard box, and tape the
flaps with adhesive tape. Furthermore, store it in a wooden box as
required by the transportation distance or method.
5. During transportation, place it under an environment that meets
the conditions described in Section 8.2 “Cautions on Storage”.
8.4 Calibration
Regular maintenance such as periodic inspections and calibration is
essential for the Signal Quality Analyzer Series for long-term stable
performance. Regular inspection and calibration are recommended for
using the Signal Quality Analyzer Series in its prime condition at all
times. The recommended calibration cycle after delivery of the Signal
Quality Analyzer Series is twelve months.
If you require support after delivery, contact an Anritsu Service and
Sales office. Contact information can be found on the last page of the
printed version of this manual, and is available in a separate file on the
PDF version.
We may not provide calibration or repair if any of the following cases
apply.

Seven or more years have elapsed after production and parts for the
instrument are difficult to obtain, or it is determined that reliability
cannot be maintained after calibration/repair due to significant wear.

Circuit changes, repair, or modifications are done without our
approval.

It is determined that the repair cost would be higher than the price of
a new item.