Anritsu MT1810A - Automatic Measurement Commands; Auto Search

7.4 Automatic Measurement Commands
7-37
7
Remote Commands
7.4 Automatic Measurement Commands
This section describes only the MP1862A measurement application
commands that are changed from MU183040A/B. For details on the auto
measurement functions, refer to the
MU183040A/B Operation Manual .
Make sure to specify the auto measurement function you want to operate
with the :SYSTem:CFUNction command before executing an auto
measurement command. For details on the :SYSTem:CFUNction
command, refer to Section 7.2.1 “Configuration Commands”.
7.4.1 Auto Search
Before using a command described in this section, make sure to set Auto
Search with the following command:
:SYSTem:CFUNction ASE32
Figure 7.4.1-1 Auto Search Window
[1]
[2]
[4] [3],[5]
[6]
[7]
[8]
[9]
[10]