Appendix D Fault Diagnosis Tool
D-6
D.4 Remote setting
This tool performs a diagnosis via an Ethernet using remote functions.
Set the remote setting to Ethernet in the Setup Utility. For details of the
Setup Utility and remote settings, refer to the MX180000A Operation
Manual.
Note:
To use Ethernet remote with the MP1800A, Option MP1800-x02 is
required.
The remote settings for this tool are set by selecting Tool and then
Remote Interface in the menu.
The initial settings are as follows:
Remote Host: 127.0.0.1 (Loopback address)
Remote Port: 5001 (MP1800A default)
To Next Page
Loading...
