Anritsu MT1810A - Exiting MX180000 A

Chapter 2 Before Use
2-16
2.2.3 Exiting MX180000A
When connecting to MP1800A:
(1) Press and hold the power switch on the MP1800A front panel or
click the
Shut down
button on the selector screen. After the
application are shut down, the MP18000A Power lamp goes off, and
then the Standby LED lights up.
(2) Set the MP1862A power switch to OFF.
The LED lights orange, indicating the standby status.
When connecting to control PC:
(1) Close
Main application
to display the selector screen.
(2) Press
Exit
on the selector screen to close the window.
(3) Set the MP1862A power switch to
OFF
.
The LED lights orange, indicating the standby status.
Notes:
•
To cut the power without following the above procedure, press
the MP1862A power switch for more than 10 seconds to enter
the standby status.
•
Do not disconnect the power cord and AC adapter without first
turning off the MP1862A as described above, otherwise the
MP1862A may be damaged.