Anritsu MT1810A - Page 237

A-1
Appendix
Appendix A
Appendix A
List of Initial Settings
Appendix A describes the default settings for MP1862A.
To initialize all the settings to the factory defaults, click the
File
menu,
and then click
Initialize
.
Table A.1-1 List of Default Settings for MP1862A
Setting
Function
Main Item Secondary Item Tertiary Item Default Setting
Result
Switch of
setting items
Result display format
Error/Alarm
Time display format
Date
&
Time
Error/Alarm display
Error/Alarm
measurement result
zoom display
OFF
Start of Error/Alarm measurement
—
Stop of Error/Alarm measurement
—
Interface
Data Input
Input Condition
Single-Ended
Data/XData selection
Data
Data input threshold
0.000 V
XData input threshold
0.000 V
Data input threshold differential type (Alternate)
Data-Xdata
Data input threshold differential type (Alternate)
0.000 V
Data input termination setup dialog box display
—
Data input termination condition
GND
Data input termination voltage
0.00 V
Clock Input
Selection
External Clock
Clock phase unit
mUI
Clock phase variable (mUI)
0 mUI
Clock phase variable (ps)
0.00 ps
Clock phase calibration
—
Clock Delay Relative selection
OFF
Jitter Input
OFF
Clock Input Band
Half Rate Clock
Misc
Information of linked ED
—
Settings for linked ED
—
— DEMUX/ED Link
OFF