For Safety
iv
WARNING
•
This equipment should always be positioned in the correct manner. If
the cabinet is turned on its side, etc., it will be unstable and may be
damaged if it falls over as a result of receiving a slight mechanical
shock.
Always set up the equipment in a position where the power switch
can be reached without difficulty.
CAUTION
•
Always remove the main power cable from the power outlet before
cleaning dust around the power supply and fan.
- Clean the power inlet regularly. If dust accumulates around the
power pins, there is a risk of fire.
- Keep the cooling fan clean so that the ventilation holes are not
obstructed. If the ventilation is obstructed, the cabinet may
overheat and catch fire.
•
Never input a signal of more than the indicated value between the
measured terminal and ground. Input of an excessive signal may
damage the equipment.
This equipment is designed for an industrial environment.
In a residential environment, this equipment may cause radio
interference in which case the user may be required to take adequate
measures.
Exposure to corrosive gases such as hydrogen sulfide, sulfurous acid,
and hydrogen chloride will cause faults and failures.
Note that some organic solvents release corrosive gases.
Falling Over
Cleaning
Check Terminal
Residential
nvironment
Corrosive
To Next Page
Loading...
