Anyview A6 - Page 154

Patient monitor User’s manual
Chapter 16-5
document attached to the Swan-Ganz catheter, which depends on the injectate
volume, temperature and the catheter type. To change this value, please select
the catheter constant in the window of 【Setup C.O.】, and input the correct
value.
6） 【 Weight 】 : Set the correct patient’s body weight, which is used to
calculate the hemodynamic and other parameters.
7
） 【
Height
】
: Set the correct patient’s height, which is used to calculate the
hemodynamic and other parameters.
8） 【TEMP Unit】: ℃ or ℉ is optional.
16.5.3 Alarm Settings
（
1
）
Select the
【
Alm Setup
】
in the menu of
【
C.O. Setup
】
to set the
alarm of C.O. Parameter，then select the【Alm Limit Setup】.
You can set the【Alm Switch】to【On】or【Off】in the menu of【Alm
Limit Setup
】
to open or close the alarm.
You can set the 【Alm Level】 to【Low】,【Med】or【High】in the menu
of【Alm Limit Setup】, the alarm is divided into low, med and high according
to the severity of the alarm.
You can set the【Hi Lmt】 in the menu of 【Alm Limit Setup】 to set
the alarm upper limit of the blood temperature.
You can set the
【
Lo Lmt
】
in the menu of
【
Alm Limit Setup
】
to set the
alarm lower limit of the blood temperature.
（2）Select the【Alm Volume】in the menu of【Alm Setup】，you can
select the alarm volume to
【
Silence
】
or the volume form
【
1
】
to
【
10
】
as required.
16.5.4 Hemodynamic
Select the 【C.O. Measure】 in the menu of 【C.O. Setup】, and select
the 【Hemodynamic】 in the menu bar below the C.O. measurement window
to open the hemodynamic window.
Important hemodynamic parameter values are displayed in the
hemodynamic window. These parameters consist of parameters for monitoring
and parameters for calculation. Select the
【
Calculation
】
to switch the
display of parameters for monitoring and parameters for calculation.
Parameters for monitoring refer to the input values which can be obtained