•
Remove the plastic bushing (9).
•
Remove the spring (5). Completely
drain inside the sleeve the oil settled on
the turns of the spring so as not to be
forced to top-up or change the oil.
•
Empty the oil into the container as
shown in the figure.
CAUTION
FOR EASY DRAINAGE OF THE OIL INSIDE THE PUMPING
MEMBER ROD, PRESS THE STEM IN THE WHEEL HOLD-
ER SLEEVE TO PUMP OIL OUT.
•
Slide off the preloading pipe.
MXV 450 Suspensions
SUSP - 175
To Next Page
Loading...
