•
After warming up the crankcase
halves, remove the bearings with an
extractor from the inside.
TIMING SYSTEM SHAFT BEARING REMOVAL
•
Remove the bearing grub screw and
the corresponding plate.
•
Warm up the crankcase halves.
•
Remove the bearing with an extractor
from the inside.
Removing the crankshaft
•
Remove the crankcase on the flywheel
side.
•
Take out the crankshaft.
See also
Splitting the
crankcase halves
Engine MXV 450
ENG - 134
To Next Page
Loading...
