APRILIA MXV 450 - Page 33

•
Stop the engine.
•
Wait some minutes for the oil to flow
from the transmission to the clutch.
•
Keep the vehicle upright with the two
wheels on the ground.
•
Remove the rear brake lever by undo-
ing the screw (1).
•
Unscrew and remove the cap/dipstick
(2).
•
The oil level is correct when it is close
to the cap/dipstick (2) opening.
If necessary:
•
Remove the filler cap (3).
•
Top-up with oil up to the cap/dipstick
(2) opening.
CAUTION
DO NOT ADD ADDITIVES OR OTHER SUBSTANCES TO
THE FLUID.
WHEN USING A FUNNEL OR ANY OTHER ELEMENT,
MAKE SURE IT IS PERFECTLY CLEAN.
•
Wait some minutes to allow the oil to flow from the clutch to the transmission. Then check
the oil level again.
Replacement
•
Lower the oil pan guard.
•
Place on the left side of the vehicle a
container of adequate capacity under
the drainage plugs (3).
•
Unscrew and remove the drainage
plug (3).
•
Unscrew and remove the filler plug (2).
MXV 450 Maintenance
MAIN - 33