Media and Ink Cartridges
QL-E100 User Guide 33
8. Locate the adjustable media guide on the right side of the media entry slot. Loosen the screw
and slide the guide to the right.
Unroll a small amount of labels. Then feed the first label of the roll into the media entry slot.
Make sure the edge of the media is against the left side of the slot.
Gently and evenly advance the media into the slot until the printer clamps the media and pulls
it inward. Slide the adjustable media guide against the edge of the media. Then tighten the
screw.
9. Close the upper lid.
10. If you replaced an empty label roll during a print job, the print job will resume. Any unfinished
labels will be printed. Receive the printed labels.
To Next Page
Loading...
