Rubber Track Loader
8. Hydraulic Reservoir Disassembly and Assembly
8-7
Reservoir Gauge Removal and
Installation
The tools required for reservoir gauge removal and
installation are listed in Table 8-4. Use manufac-
turer-recommended tools whenever possible.
Table 8-4
Required Tools
Combination Wrench
Reservoir Gauge Removal
! WARNING !
Hot oil can cause personal injury. Make sure the oil is
cool before removing any components or lines.
Remove the oil filler cap only when the engine is
stopped and the filler cap is cool enough to touch with
your bare hand.
NOTICE
Collect and contain liquids in a suitable container. Dispose
of all liquids according to local regulations and mandates.
Note: During disassembly, cap all hoses and fittings to
prevent fluid loss and contamination of the system fluids.
1. Drain the hydraulic fluid. Refer to Chapter 16.
Hydraulic Fluid and Filter Change.
2. Remove the filter assembly. Refer to Chapter 8.
Filter Assembly Removal.
Figure 8-25 8-016
3. View of hydraulic reservoir with filter assembly
removed.
Figure 8-26 8-017
4. Reach inside the reservoir and remove the two
nuts that fasten the reservoir gauge to the reser-
voir.
Figure 8-27 8-018
5.
Pull the reservoir gauge and the two mounting
bolts/washers off the reservoir. DO NOT mis-
place the rubber washers or the reservoir will
leak.
Remove Res-
ervoir Gauge
with Mounting
Bolts/Washers
https://www.tractormanualpdf.info/
To Next Page
Loading...
