Rubber Track Loader
12. Undercarriage Disassembly and Assembly
12-14
Figure 12-57b 12-037b
3. Remove the bolts that fasten the drive motor to
the drive table. Three of the four bolts can be re-
moved using conventional tools.
Figure 12-58 12-037
4. Using a "crows foot" attachment, remove the
fourth bolt that fastens the drive motor to the drive
table.
Figure 12-59 12-038
5. Remove the drive motor by rotating, or indexing
it until it fits through the opening. Once out, cap
all hydraulic fittings on the drive motor.
Drive Motor Installation
1. Position the drive motor so the hydraulic fittings exit in
the correct location. Install the drive motor bolts.
Clean and inspect the drive motor shaft.
2. Reinstall all hoses and fittings.
3. Reinstall drive sprocket as outlined above.
https://www.tractormanualpdf.info/
To Next Page
Loading...
