ASV RC30 - Track Installation

Rubber Track Loader
12. Undercarriage Disassembly and Assembly
12-8
Track Installation
! WARNING !
To install the tracks, the machine must be jacked up and
placed on jack stands sturdy enough to support the weight
of the machine. The manufacturer-supplied jack stands
are recommended.
Track
Drive
Lu
g
s
Figure 12-31 12-047
1. Place the track around the back wheels and on
top of the drive sprocket. Make sure the track
drive lugs mesh with the sprocket.
Apply
Soa
p
Figure 12-32 12-048
2. Using soap, lubricate the front inside wheel. Pull
the track past the outside wheel shaft and onto
the front inside wheel. The soap will help the
track slide onto the wheel.
Figure 12-33 12-049
3. Install the front wheel. Refer to Chapter 12.
Wheel Installation.
Align
Hole
s
Figure 12-34 12-052
4. Pry the sprocket up until the holes in the track
tensioner and drive sprocket are aligned. A floor
jack or a second pry bar may be needed to get
the drive table off the rail.
Tighten
Bolt
Figure 12-35 12-053
5. Install and tighten the track tensioner bolt and
nut.
https://www.tractormanualpdf.info/