Rubber Track Loader
12. Undercarriage Disassembly and Assembly
12-9
Figure 12-36 12-054
6. Install the remaining wheels making sure the
wheel nuts, o-rings, wheel caps, and snap-rings
are properly installed. Refer to Chapter 12.
Wheel Installation.
Figure 12-37 12-055
7. Tighten the track by turning the track tensioner.
When proper track tension has been achieved,
tighten the jam nut on the track tensioner.
8. Check for proper track tension. Refer to Chapter
16. Maintenance – Checking for Proper Track
Adjustment
Sprocket Bearing Plate
Removal and Installation
The tools required for sprocket bearing plate re-
moval and installation are listed in Table 12-5. Use
manufacturer-recommended tools whenever possi-
ble.
Table 12-5
Required Tools
Socket Wrench Allen Wrench
Combination Wrench Torque Wrench
Steel Punch
Sprocket Bearing Plate Removal
1. Remove the track. Refer to Chapter 12. Track
Removal.
2. Move the brake away from the sprocket. Refer
to the Chapter 12. Brake Removal.
Figure 12-38 12-023
3. Remove the bolt on the left that secures the
bearing plate to the drive table.
Figure 12-39 12-024
4. Remove the bolt on the right that secures the
bearing plate to the drive table.
Jam Nut
Track
Tensioner
https://www.tractormanualpdf.info/
To Next Page
Loading...
