Parameter name Default
value
Description
REGISTERWAIT 900 Specifies the number of seconds
between re-registrations with the
current server. Valid values are
from 30 to 86400.
REUSETIME 60 Specifies the number of seconds
that the DHCP is attempted:
• With a VLAN ID of zero. True
when L2Q is set to 1.
• With untagged frames. True if
L2Q is set to 0 or 2.
• Before reusing the IP address
and the associated address
information, that the phone had
the last time it successfully
registered with a call server.
While reusing an address, DHCP
enters the extended rebinding state
described above for DHCPSTD.
Valid values are 0 and 20 through
999. The default value is 60. A
value of zero means that DHCP will
try forever and there will be no
reuse.
RINGTONES Null Specifies a list of display names
and file names or URLs for a
custom ring tone files to be
downloaded and offered to users.
The list can contain 0 to 1023
UTF-8 characters. The default
value is null.
Values are separated by commas
without any intervening spaces.
Each value consists of a display
name followed by an equals sign
followed by a file name or URL.
Display names can contain spaces,
but if any do, the entire list must be
quoted. Ring tone files must be
single-channel WAV files coded in
ITU-T G.711 u-law or A-law PCM
with 8-bit samples at 8kHz.
Table continues…
Customizable parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 294
Comments on this document? infodev@avaya.com
To Next Page
Loading...
