Aux Page
Avidyne EX500/EX600 MFD -84- 600-00078-001 Rev 05
about MultiLink, see Setting Up Datalink for ORBCOMM
(Release 4.0 and earlier) on page 113.
■ If only Broadcast Datalink is installed, this key is not
displayed. The EX500/EX600 will be configured for
Broadcast Datalink by the installer.
2) Lightning Strk Test - Initiates a self test of the lightning sensor
and switches to Map page for the display of test results.
3) Traffic Standby - Switches traffic sensor into standby mode (only
while on the ground). To re-enable the display of traffic data while
on the ground, press the Traffic key on the Map page.
4) Nav Src - Selects GPS A or GPS B input source (if dual GPS’s
are installed and wired to the EX500/EX600).
5) Displays - Software part number, hardware serial number, media
part number, and the effective dates of navigation and chart
databases.
6) Message List (including sensor status) - This display area is for
system informational messages on the EX500/EX600. This list is
not chronological—each type of sensor is assigned to a position
in the list for its related messages.
7) Airport Filter - Provides options for selecting the types of airports
that will be displayed on the Map and NRST pages.
8) Declutter Setup - Provides options for selecting the amount of
data that will be displayed at various Zoom and Declutter levels
on the Map page.
9) Data Blocks - Allows you to tailor the type of information
displayed in the data blocks on the upper right-hand corner of the
Map page.
10) System Time - Provides options for setting the system date and
time and for tailoring the behavior of the menu key time-outs.
11) Scroll knob - Controls the cursor to allow you to review all the
messages in the message list.
To Next Page
Loading...
