Figure 10 Installing the Video Reader Pro on the standard mount
Video Reader Pro wiring
Connector type Description
Ethernet RJ-45 connector
Table 6 Connection to Avigilon cloud
Pigtail color
Short name Full name
Black GND Wiegand RTN
Green WD0 Wiegand Data 0
White WD1 Wiegand Data 1
Table 7 Connections to third-party controller (optional)
Pigtail color Short name Full name
Blue and white stripe NO Relay Normally Open*
Orange and white stripe COM Relay Common*
Green and yellow stripe GND Ground (RTN)*
Table 8 Connections to third-party device (optional)
*Relay is not rated for locking hardware. To power locking hardware, use an Avigilon Smart Hub or third-party
access control panel.
1. Use the provided waterproof coupling (c) to connect the RJ-45 jack (a) to an Ethernet cable (Cat 5e, 26
AWG or better), which is connected to a networked Power over Ethernet (PoE) source (b).
2. Optional. Use the NO and COM stripe wires to connect to a third-party device. Use the WD0 and WD1
wires to connect to an input on the panel of a legacy access control system.
Power up the Video Reader Pro
1. Connect the Video Reader Pro to a PoE injector or PoE-powered switch.
2. Power on the Video Reader Pro.
Installation 36
To Next Page
Loading...