*Relay is not rated for locking hardware. To power locking hardware, use an Avigilon Smart Hub or third-party
access control panel.
1. Use the provided waterproof coupling (c) to connect the RJ-45 jack (a) to an Ethernet cable (Cat 5e, 26
AWG or better), which is connected to a networked Power over Ethernet (PoE) source (b).
2. Optional. Use the NO and COM stripe wires to connect to a third-party device. Use the WD0 and WD1
wires to connect to an input on the panel of a legacy access control system.
Power the Video Intercom Reader Pro
1. Connect the Video Intercom Reader Pro to a PoE injector or PoE-powered switch.
2. Power on the Video Intercom Reader Pro.
Provision the Video Intercom Reader Pro
Note: You must first create a Video Intercom Reader Pro in the Alta Control Center.
For more information, see
Add a Video Intercom Reader Pro
in the Avigilon Alta Control Center Administrator
Guide.
Use the Open Admin app
1. Open the Open Admin app.
2. Search for org name.
3. Press Admin button (see figure on the next pages) on the back of reader.
Note: Remove the back cradle to expose the Admin button.
4. Tap the serial number of the reader in the Open Admin app.
5. Tap Provision Devicein the Open Admin app and follow in-app instructions.
Use the Alta Control Center
1. Go to control.openpath.com/loginand sign in. To access the European Alta Control Center, go to con-
trol.eu.openpath.com/login.
Installation 43
To Next Page
Loading...
Need help?
General