Appendix
AX3000 Model 80WMS - User's Manual 101
Two types of router can be used to access remote networks:
- A default router: this router knows how to reach many remote networks.
- Specific routers: in charge of one remote network.
The default router is only identified by an IP address.
The specific routers are identified by the following parameters:
- Router IP address: this router must be connected to the same network
as the AX3000.
- Destination IP Address: IP address of the host or the network to be
reached.
- Destination Type: two values:
- Host: the destination is a single host,
- Network: the destination is a whole local network (the class mask
is applied to this IP address).
Notes:
- At the AX3000 level, the routing algorithm uses a specific router to reach
the destination. If no specific router fits, the default router is used.
- The AX3000 doesn't support ICMP REDIRECT requests (dynamic routers
are not supported).
To Next Page
Loading...
Need help?
General
