Using the AX3000
66 AX3000 Model 80WMS - User's Manual
This chapter covers use of the AX3000.
4.1 - SWITCHING ON THE AX3000
The following operations are performed when the terminal is turned-on:
- Boot: initialization, network detection...
- Auto-configuration (optional): checks over the network if a new
firmware/configuration is available. If yes the terminal reboots again for
the new firmware/configuration to take effect (for more information see
Chapter 2.2)
- Auto-Connection: the RDP session is opened automatically if the 'auto-
connection' parameter is set to 'yes'. See Chapter 4.3.1.
- Local Desktop: if no screen session is connected, the terminal Local
Desktop is displayed. See next Chapter.
4.2 - LOCAL DESKTOP
The local desktop is displayed when there are no current active sessions or if
the 'Desktop' icon (in the left of the taskbar) had been clicked.
The local desktop appearance depends on the taskbar style (see Chapter
3.2.3).
The local desktop is organized as:
- The main area contains the MultiPoint session icon
- The taskbar is displayed on the bottom of the screen.
To Next Page
Loading...
Need help?
General
