Initial Power-On
AX3000 Model 80WMS - User's Manual 9
Note 2: this list contains MultiPoint server names who responded in less than 3
seconds to multicast requests sent on UDP port 3702. An empty list may
indicate no server is installed on the same subnet as the thin client or requests
are blocked by a firewall.
The [Refresh] button allows the list to be built again. The delay to collect data is
now 5 seconds.
The [Enter New Server] button allows the server name (or IP address) to be
manually entered.
Confirming this box configures the thin client with a dynamic IP address
(obtained by DHCP) and an RDP session with a high user experience (32bpp,
audio, theme...).
Note: to enter the full interactive set-up (see Chapter 3) press
<Ctrl><Alt><Esc> instead of confirming this dialog box.
2.2 - AUTO-CONFIGURATION
The Auto-Configuration feature allows a brand new ‘out of the box’ terminal to
be sent a specific firmware and/or configuration file without any human
intervention. There are also options to specify various terminal specific
parameters, for example an IP address and terminal name etc.
For more information on AxRM’s activity in the auto-configuration process, see
the manual "Axel Remote Management - Version 3", available from
www.axel.com.
The auto-configuration process:
- Is automatically initiated when power is applied to a brand new terminal or
if the terminal is reset to factory defaults - see A.10.1 appendix.
- may be started at each boot time. For more information see Chapter
3.6.2.
The stages are:
- Checking the network (link),
To Next Page
Loading...
Need help?
General
