Appendix
AX3000 Model 80WMS - User's Manual 121
The keepalive function is set in minutes
Note: with ISDN routers (which automatically drop the phone line) this regular
data flow will prevent the router from hanging-up. In this scenario the keepalive
can cause expensive phone bills.
g) 'Additional Time-Out for Reconnection (sec)' Parameter
When the MultiPoint session is set in 'auto-reconnection' mode, the
reconnection is attempted immediately after the disconnection.
If needed, this option allows this reconnection to be delayed.
A.6.4 - Setting the IP Address by a PING Command
The administrator can remotely assign an initial IP address to a brand new
terminal, or remotely change an existing IP address.
The procedure is to manually modify the ARP table of your computer (Unix,
Linux, Windows...). An ARP table entry is composed of IP addresses and
Ethernet MAC addresses. The command below associates an arbitrary IP
address to the terminal’s hard coded MAC address. The MAC address is printed
on the base of each terminal. With its updated ARP table your computer is able
to access the AX3000.To set the new IP address the terminal must be pinged a
multiple times.
Using under Windows:
: Windows administration s/w (AxRM or Axel Remote Management) is
available free on the Axel Web site. See Chapter 5.2.
ARP table modification (Ethernet address notation, '-' are used as separators
instead of ':'). The command is:
C:\> arp -s a.b.c.d xx-xx-xx-xx-xx-xx
Run one or more ping commands (4 ping requests are sent by ping command):
C:\> ping a.b.c.d
To Next Page
Loading...
Need help?
General
