Interactive Set-Up
24 AX3000 Model 80WMS - User's Manual
The server definition depends on whether DNS is enabled:
- No DNS: a server is identified by both an alphanumeric character string
beginning with a letter AND an IP address.
- With DNS: a server is defined only by its name. This name can be either
a full name (wms2011.servers.axel.com) or an incomplete name
(wms2011). Its IP address is resolved later. (See Appendix A.4)
Add a Server: move the highlight cursor to a vacant line and enter the name
and either its IP address or DNS name.
Delete a Server: select the server and press [Delete].
Change a Server: move the highlight cursor over the name or IP address of the
server and enter the new value.
Note: the default DNS domains, previously defined through the DNS box are
displayed for information (they can not be modified).
3.1.4 - SSL Security
When an SSL connection is established it is advisable to check the server
certificate.
This requires a CA certificate to be installed in the AX3000 Local Store. See
Chapter 3.6.4.
To configure the terminal SSL security policy, select the [Configuration]-
[Network]-[SSL Security] menu. A dialog box as shown below is displayed:
The 'Reliability Verification' option forces the server certificate to be checked
To Next Page
Loading...
Need help?
General
