Axel AX3000 80WMS User Manual

Appendix
AX3000 Model 80WMS - User's Manual 105
address on boot, the message 'DHCP in progress' is displayed on the bottom of
the screen.
Note: the search can be aborted by entering the set-up.
If a DHCP (or BOOTP) server is available an IP address is given after a few
seconds. This dialog box is then cleared and the AX3000 follows its normal
behavior: either the set-up idle is displayed (no automatic session is set) or an
automatic connection is opened.
Further 'lease time' re-negotiations are totally invisible to the AX3000 user. Only
error messages are displayed (see next chapter).
Note: enter the set-up to find out the AX3000 IP address or other parameters
offered by the DHCP server.
A.3.4 - Errors
a) Boot Time Failure
The AX3000 automatically searches for a DHCP server on booting. If after 30
seconds no DHCP (or BOOTP) server answers the following dialog box is
displayed:
At this stage two options are available:
- <F11>: rebooting the AX3000 to run the DHCP search again.
- <Ctrl><Alt><Esc>: entering the set-up to modify AX3000 settings.
b) Re-negotiation Failure
The lease time must be regularly re-negotiated (except if the IP address has

Axel AX3000 80WMS Specifications

General

Brand	Axel
Model	AX3000 80WMS
Category	Server
Language	English