Baldor Flex+DriveII Installation Manual

Accessories A-1MN1902
A.1 Introduction
This section describes accessories and options that you may need to use with your
FlexDrive
II
. Shielded (screened) cables provide EMI / RFI shielding and are required for
compliance with CE regulations. All connectors and other components must be compatible
with the shielded cable.
A.1.1 Factory fitted options
The FlexDrive
II
can be supplied with a number of factory fitted options. Each option is
described in a separate manual that will be supplied with your product as necessary:
H MN1908 - CAN & Auxiliary I/O Option for Flex+Drive
II
and MintDrive
II
.
Option B provides CANopen and additional input / output capabilities. If this option is fitted,
the Flex+Drive
II
front panel will include connectors X10, X11 and X12.
H MN1909 - CAN Option for FlexDrive
II
, Flex+Drive
II
and MintDrive
II
.
Option C provides CANopen capabilities. If this option is fitted, the FlexDrive
II
front panel
will include connectors X10 and X11.
H MN1910 - DeviceNet Option for FlexDrive
II
, Flex+Drive
II
and MintDrive
II
.
Option D provides DeviceNet capabilities. If this option is fitted, the FlexDrive
II
front panel
will include connector X15.
H MN1911 - PROFIBUS DP Option for FlexDrive
II
, Flex+Drive
II
and MintDrive
II
.
Option P provides Profibus capabilities. If this option is fitted, the FlexDrive
II
front panel
will include connector X14.
A Accessories
A

Baldor Flex+DriveII Specifications

General

Brand	Baldor
Model	Flex+DriveII
Category	Servo Drives
Language	English