Baldor Flex+DriveII Installation Manual

3-34 Basic Installation MN1902
3.9.8 Preventing a program running at startup
Flex+Drive
II
only:
If switches 5 and 9 are set to On and switch 8 is set to Off, any program already in the
Flex+Drive
II
that contains an Auto command will be prevented from running automatically at
startup.
On5
Reapply power. Mint program
with Auto command will not run.
1. 2.
On9
3.
Off 8
Remove
power.
Figure 21 - Preventing the Auto command from running a stored Mint program
This completes the basic installation.
You should read the following sections in sequence
before attempting to st art the FlexDrive
II
.

Baldor Flex+DriveII Specifications

General

Brand	Baldor
Model	Flex+DriveII
Category	Servo Drives
Language	English