25R5900102 /11 ClickShare CX-20
3.5 Standalone setup
Overview
This setup is the simplest in terms of installation and can be used for temporary setups and in organizations
where central management and 3rd party integration are not required.
The ClickShare Base Unit and Button (s) operate directly out of the box, without any integration in the
Enterprise network. It is advised to connect the Base Unit at least once to the internet in order to check for
updates and register your device for SmartCare. Users can connect directly to the Base Unit via the
ClickShare Buttons, after the Button are paired to the Base Unit, or using the ClickShare App or Miracast or
with their mobile devices using Airplay or Google Cast.
Using a ClickShare Button allows you to stay connected to the internet. Users who wish to share with the
ClickShare Desktop App, ClickShare Mobile App, AirPlay and Chromecast will have to connect to the Base
Unit’s access point and will only be able to access the internet if the device supports to use data (3G/4G) at
the same time. Note that this requires the Base Unit’s access point is not turned off, is visible and can be
connected to by anyone.
Sharing via Miracast will only be possible via Wi-Fi direct.
Using the ClickShare Base Unit and Buttons directly out of the box is ideal for temporary setups, visitor
centers and small to medium installations without network integration needs or possibilities. This setup
requires the least installation effort and keeps any shared data completely separated from your Enterprise
network. Updating and configuring the Base Units will need to be done manually.
Image 3–4
CX-20 Installation
To Next Page
Loading...
Need help?
General
