R5900102 /11 ClickShare CX-2084
5.8 Peripherals
Overview
ClickShare Conference allows you to connect the room speakerphone, microphone and camera wireless to
your laptop and use the better equipment of the room in your video conferencing call.
The Peripheral page gives an overview of the connected devices and their status.
Firmware update peripherals
Update of firmware of the peripheral devices via the configurator is supported for Logitech Meetup and Rally
and only when the camera is not in use.
When the installed firmware version is lower than the Barco certified peripheral firmware version, then the
install button becomes active. Click on Install the install the latest version.
How to get an overview
1. Log in to the Configurator.
2. Click Display & Audio → Peripherals.
An overview of the status of the Speakerphone Device, microphone and speaker, and Camera device is
given.
Image 5–14 Peripherals
Quality score camera
When the camera is in use, a quality score is given between 0 and 100. It gives an indication what’s going on
with the camera stream quality and format change. The quality score reflects the image quality, where zero
means the lowest quality accepted by ClickShare (lowest bandwidth) and 100 means the maximum quality
available by the camera (highest bandwidth). This is unrelated to the format resolution or framerate. The
quality is adjusted to meet the requested framerate, if the framerate cannot be reached, the quality is
lowered. If the lowest quality is reached, there is no other way to meet the framerate. Therefore the quality
score will be equal to zero.
Quality score, normalized value between 0 and 100.:
CX-20 Configurator
To Next Page
Loading...
Need help?
General
