105R5900102 /11 ClickShare CX-20
5.20 Services, Mobile devices
ClickShare app
The ClickShare app is enabled by default and makes it possible to connect with a mobile device to the Base
Unit.
About streaming information via AirPlay
Before you can stream information and display it via ClickShare your device must be connected with the
wireless network of the Base Unit. Then AirPlay must be activated on your device. For more information about
activating AirPlay, consult the user guide of your device.
The supported versions of AirPlay can be found on Barco’s website, www.barco.com\clickshare. The support
of non-released version of these protocols cannot be guaranteed by Barco.
About streaming via Google Cast
Before you can mirror information and display it via ClickShare your device must be connected with the
wireless network of the Base Unit. When activating Google Cast on your device an overview of the access
points is given. For more information about using Google Cast, consult the user guide of your device.
The supported versions of Google Cast can be found on Barco’s website, www. barco. com \clickshare. The
support of non-released version of these protocols cannot be guaranteed by Barco.
Google Cast does not support a passcode.
Google Cast can only be used when the clock of the Base Unit is set correctly. If not Google Cast
cannot make a connection with the Base Unit.
About streaming via Miracast™
Miracast™ enables seamless display of multimedia content between Miracast® devices. Miracast allows
users to wirelessly share multimedia, including high-resolution pictures and high-definition (HD) video content
between Wi-Fi devices, even if a Wi-Fi network is not available.
Miracast sets up its own network to stream information and display it via ClickShare so there is no need for a
direct connection with the Base Unit. Miracast must be activated on your device. For more information about
activating Miracast, consult the user guide of your device.
The supported versions of Miracast can be found on Barco’s website, www.barco.com\clickshare. The support
of non-released version of these protocols cannot be guaranteed by Barco.
To be able to use Miracast, you need to disable the access point and integrate the Buttons into the
corporate network. But we do not advise using wireless conferencing when the Button does not
connect directly to the Base Unit. This limitation will be eliminated in future firmware releases.
Passcode type selection
1. Log in to the Configurator.
2. Click Wi-Fi & Network → Services.
CX-20 Configurator
To Next Page
Loading...
Need help?
General
